Couldn't load pickup availability
In stock
- Verified Original
- Secure Payments
- Quick Shipping
Ask an expert
Ask an expert
Email for more info direct to orders@cinea.co.za
Sometimes size really does matter.
The bigger the woofer, the more air you push, the more sound you get. We put Model Seven’s 13-inch woofer and half-roll rubber surround in an acoustically sealed cabinet, where the air within acts as a natural spring behind the cone. This helps Model Seven reach 26Hz (-10dB) while staying tight and well-defined at higher volumes instead of becoming loose and muddy.
We like to think it doesn’t shake the room as much as it hits you in the chest.
Model Seven is a three-way design, the woofer handles everything below 300Hz, while a dedicated 5-inch midrange—housed in its own enclosure—handles 300Hz - 3,500Hz: voices, guitars, pianos, the part of the music your ears are quickest to notice when something sounds “off”. The 1-inch aluminum dome tweeter takes it from there.
It sounds great right out of the box, but even better when you give it about eight hours of playing at moderate volume. Patience—as usual—pays.
13" Pulp-Paper Woofer - Pulp-paper cone with flat-wire voice coil and half-roll rubber surround, in a die-cast aluminum frame. Sealed enclosure, reaching 26Hz (-10dB).
5" Pulp-Paper Midrange - A dedicated driver in its own internal enclosure, for the frequencies that matter most. Pulp-paper cone, half-roll rubber surround, die-cast aluminum frame.
1" Aluminum Dome Tweeter - Smooth, extended treble with soft rubber suspension, set in a machined aluminum faceplate.
Three-Position Acoustic Balance Control - A three-position switch on the back of Model Seven, “Hi, Mid, and Lo” trims everything above 400Hz by 1.5dB–up to 3 dB–and leaves bass alone. Bright, hard-surfaced rooms tend to want more trim; while soft, carpeted ones want less.
Thirteen-Component Crossover - Iron-core inductors and Mylar capacitors, handing off at 300Hz and 3,500Hz. The crossover decides which driver plays which note. Not the place to economize.
38Hz-20kHz Frequency response (±3dB)
91dB In-room sensitivity - Relatively easy to drive, pairs comfortably with amplifiers from 20 to 250 watts.
4 ohms - Nominal impedance. Worth confirming your amplifier is comfortable with a 4-ohm load.
250W - Power handling
1,000W - Peak power handling
115dB - Maximum in-room SPL. More than you’ll need, which is the right amount of headroom.
140° - Horizontal dispersion (-6dB)
36" H x 18" W x 9.75" D, 68 lbs Per speaker, without riser. 41" H x 12.25" D and 78.8 lbs on the included riser.
